How do you get the rotor off?

0

Asked by zorro469 Nov 15, 2009 at 02:34 AM about the Acura Vigor

Question type: Maintenance & Repair

I can't get the assembly off to remove the rotor.

385

- Report

Tom answered 3 years ago

well removed the caliper. then you remove the caliper bracket usually 2 bolts that hold it in. then depending on vehciel 1-2 screws holding the rotor onto the knuckle

Mark helpful

Your Answer

Does anyone know of a good site to get parts for my 3 acura vigor gs thats not too expensive? 1 answer

i need to replace the valve seals and all the other seals

Acura Vigor

-

Maintenance & Repair
97 Acura Integra timing belt 2 answers

I changed the timing belt and now the car will not start! I tore into it and found out that the rotor in the distributor is not facing the right plug wire! How could this happen when all i did was tak...

1997 Acura Integra

-

Maintenance & Repair
I was at a stop sign and go to step on my gas and it felt like my car wanted to conk out on me, until I stepped a little hard and it started to go 1 answer

1997 Acura Integra 2 Dr GS-R Hatchback

-

Maintenance & Repair
car wont start, all electrical works 10 answers

my car wont start, all electrical components and fuel work, no spark from distributor, replaced ignition module

1994 Acura Integra 2 Dr LS Hatchback

-

Maintenance & Repair
Engine fan continues to run after car is stopped and turned off. 3 answers

Engine fan continues to run after car is stopped and turned off. Even after 5 -10 mins. I have come back and the fan is still running.

1998 Acura TL 3.2 Sedan

-

Maintenance & Repair