1988 Chevrolet Corsica Reviews, Pricing & Specs

what size bolt is on the tensioner. I need to put a new belt on, and need to loosen it up. How can I get this serpentine on!!?

what size bolt is on the tensioner. I need to put a new belt on, and need to loosen it up. How can I get this serpentine on!!?

1988 chevy corsica fuel pump breather line

1988 chev corsica 2.0 4 cylinder . With fuel pump line 2 carb and a return line back 2 the tank. Dont no wher the breather line goes.

with a 12.5 volt reading at the battery there is a zero point zero reading at the bat post on the alternator do I check the wire or have the alternator tested

i have a 1988 chevrolet corsica and wish to find out what is wrong with it

the car is a 1988 chevrolet corsica.2.0 engine..the problem is when i give it gas to enter traffic it gets sluggish.now it has died and had to be towed.after getting it to the garage i was asked to try starting it . and it started right off and sounded great.so i live 300 ft.from the garage and drove it home and it died and hasn't started since.i was told it was the fuel pump.,fuel filter,fuel relay .which one is it and how do i fix this problem its the only car i have

Chevy Corsica V6: DTC-64 Manifold Sensor Circuit Signal Low

Hi Everyone! I'm a newbie to this forum as well to Corsica's. I recently picked up a 1988 Corsica for a commuter that im trying to get to pass smog. Im having trouble with a DTC code 64. My programmer says its a MAP sensor circuit signal voltage low. From what Ive been reading low voltage= low pressure= high vacuum??? Any help to kill this fault code from popping up so i can pass smog would be great! The only symptoms the car is showing is a bit of a low idle and a very small hesitation on initial acceleration. I found cracked vacuum hoses going to the MAP sensor as well as replaced the sensor with a brand new one. And unfortunately the code keeps popping up after I reset it. Any other suggestions??? Thanks for your help in advance! Regards