Mazda Protege Questions Any type

  • Newest
  • Recently Active
  • Unanswered
tonybrown1
0

Oil Light

oil light is on before i turn the key 2 start the but the car wont start it just turn over.

3 views with 1 answer (last answer 2 days ago)
Logan Brown
0

I Have Put New Fuse In My 1990 Madza Protege And And It Wont Crank Every Th...

But he main reasons is the engine not turning over so any body pleased help I know the engine is good because I crank it the day before

9 views with 1 answer (last answer about a week ago)
1234321abab
0

1999 Mazda Protege Makes Loud Noise Under The Hood When Ac Or Fan Turned On...

I have a 1999 Mazda protege . It makes a loud squealing noise under the hood when the fan or ac is turned on. It stops when I turn off the fan off .

4 views with 1 answer (last answer about a week ago)
carfind145k
0

Re: My Auto Insurance To Supply A Replacement Car: Is My 1992 Mazda Protege...

California law quotes actual cash value of a totaled car as the market-driven, "fair-market-value of a comparable replacement." My 1992 Mazda Protege, 4cyl sedan, has 145k miles. Must I settle for an...

61 views with 9 answers (last answer about a week ago)
kerstinclemmons
10

Check Engine Light On Cylinder 3 Misfire

My 02 Mazda Protege is throwing a cylinder 3 misfire code. Changed all spark plugs and both coil packs also both o2 sensors. Idols fine in park but idols below 1000rpm in drive. it chugs but runs fine...

32 views with 2 answers (last answer 2 weeks ago)
Tracilla Dawson
10

I Have A 2000 Manual Mazda Protege It Keeps Dieing.

The battery was dead so I jumped the car it ran for about 30 seconds and then it died, so I jump started it again and let it sit idling and after about 20-30 seconds it died again and each time the ba...

21 views with 4 answers (last answer 2 weeks ago)
Angela Cochran
0

02 Mazda Protege Alarm Won't Allow Car To Start

Battery died unexpectedly. Charged it and while putting it back in the alarm sounded. I was able to reset it by unlocking and locking the doors with the key but soon as I tightened the cables on ...

savanna98
0

Guru, My Engine Light Is On, If I Install The New Master Airflow Sensor Wil...

1.6 liter motor

15 views with 5 answers (last answer about a month ago)
ppasionek602
0

Please Help I Replaced The Starter , Battery, Ignition Switch, In A 2000 Ma...

Replaced the starter, battery, ignition switch , the car will not crank over.

39 views with 1 answer (last answer about a month ago)
geoffry333
0

I Can Not Get At Some Of The Bolts To Get The Transmission Fluid Changed.

There is a cross member in the way of the bolts. Does that cross member need to be removed. Or is there something possibly bent like the cross member that restricts access to the bolts? Anyone ha...

12 views with 1 answer (last answer about a month ago)
Mazda12
5

If You Use An Obdii Scan Tool To Delete Diagnostic Trouble Code(s), Then Ho...

When you plug in an OBDII scan tool it should say: DTC 0 and IM Ready Yes But after you get the check engin light and use the scanner to delete it it says: DTC 0 and IM Ready No. How can you get it ...

30 views with 2 answers (last answer about a month ago)
c_flanagan
0

Some Lights On The Dash Are Out Also The Light On The Automatic Shift Are O...

how do I take the dash apart to replace bulbs that are burnt out, also the light on the shift colum is out .

michaelmoore
25

2003 Mazda Protege5 Blown Fuse

my licence plate bulbs went out, and ever since then I've had the fuse for my dash and running lights go out any advice would be grealy appreciated

20 views with 1 answer (last answer 2 months ago)
jmac_73
0

Noisy Cab And Vibration In Steering Wheel

Very loud in cab of car, vibration in steering wheel?I have a 2003 Mazda Protege. I had the front drivers side axle and steering knuckle replaced, since then the cab noise and vibration in the ste...

27 views with 1 answer (last answer 2 months ago)
DavidChurch
0

Try To Jump Start, No Panel Lights Are On, And No Noise At All When Trying ...

Jump started before, I sigure perhaps one time the jumper cables were improperly placed, if even just for a second, because now no panel lights display when trying to jump start. Absolutely no power ...

MattH9493
0

98 Mazda Protege Tires

Im wondering if R14 195/70 tires would fit on my '98 Mazda Protege ES. Currently there are R14 185/65 on there. Hopefully someone can help me out.

33 views with 3 answers (last answer 2 months ago)
1 2 3 4 5 ... 8 next

Favorite this topic

Subscribe to Mazda Protege questions.

Search Mazda Protege Questions

Mazda Protege Experts

#1 dandyoun
dandyoun
Reputation 170
#2 James Kithuka
James Kithuka
Reputation 100
#2 Tom Demyan
Tom Demyan
Reputation 100
View All

Related Models For Sale

Used Mazda Protege5"
4 Great Deals out of 190 listings starting at $1,700
Used Honda Civic"
808 Great Deals out of 56,239 listings starting at $995
Used Toyota Corolla"
1,144 Great Deals out of 53,642 listings starting at $995
Used Mazda MAZDA3"
558 Great Deals out of 29,599 listings starting at $2,800
Used Honda Accord"
1,215 Great Deals out of 64,489 listings starting at $1,089.41
Used Mazda 626"
7 Great Deals out of 430 listings starting at $1,995
Used Mazda MAZDA6"
250 Great Deals out of 13,680 listings starting at $2,200
Used Honda CR-V"
712 Great Deals out of 52,188 listings starting at $1,400
Used Mazda MX-5 Miata"
82 Great Deals out of 2,359 listings starting at $2,000
Used Nissan Altima"
1,514 Great Deals out of 79,443 listings starting at $1,495
Used Subaru Impreza"
170 Great Deals out of 6,406 listings starting at $2,000
Used Ford Escape"
1,334 Great Deals out of 57,266 listings starting at $950
Used Nissan Maxima"
623 Great Deals out of 19,596 listings starting at $1,495
Used Honda Civic Coupe"
228 Great Deals out of 8,380 listings starting at $4,995
Used Mazda MAZDA5"
113 Great Deals out of 3,251 listings starting at $2,787