Ford Bronco II Questions Any type

  • Newest
  • Recently Active
  • Unanswered
jgolder
40

I Have A 88 Bronco. We Replaced Th High Pressure Pump But When We Checked F...

We removed the rear line and there is flow out of the low pressure pump. Is there something we need to do. We replaced the the relay and filter also,

16 views with 3 answers (last answer 2 weeks ago)
justinspink09
0

No Spark To My 86 Bronco 2 With A 302 Ho Swap

Why am I not get spark? Have power going to coil but nothing out of it. But when I turn the key on them as I'm turning the key off it sparks once every time

18 views with 3 answers (last answer 2 weeks ago)
Rini89
0

1990 Bronco 2

Why does no electricity go to the fuel pump?

Colby Sykes
5

Wont Start

i have a 88 bronco ii and it wont start. im have a issue with the fuel system some where i believe. i rebuilt the engine it had a cracked head and it ran 100% fine before it was sitting . i jumped ...

amicalolatim
0

I Cant Find My Old Owners Manual, How Do I Tow My 1984 Bronco Ii Manual Tra...

Do I flat tow, car dolly tow, or all 4 off the ground tow my 1984 Bronco II Manual tranny 4wd 2.8L V6? Thanks

Matthew Turnupseed
0

1986 Ford Bronco Ii 4wd Xlt. I Want To Do A Complete Tune Up To It. I Would...

I want to do a complete tune up to it. I would like to know what to look for, replace etc.. Thanks!

29 views with 1 answer (last answer 2 months ago)
johnyappleseed
0

Bronco 2 Electrical Issues

Had my cab fill with smoke last night. It was also coming out vents at top of hood on passenger side outside. Stopped could not locate burnt anything took blower motor out clean nothing burnt. Pulle...

47 views with 3 answers (last answer 2 months ago)
johnyappleseed
0

1984 Gm S10 2.8 Into My 84 Bronco 2 2.8

I got a great offer on a 1984 gm s10 2.8 motor with low kms. Just the motor though no donor vehicle to go with it. Im wondering if I can put this motor in my 84 bronco 2 with the 2.8 motor in it. Wi...

17 views with 2 answers (last answer 2 months ago)
johnyappleseed
0

Bypassed Neutral Safety Switch

My truck wouldnt start turns out I broke wires going to my neutral safety switch.old switch really brittle wires. So I stripped the wire ends and started to touch them together till it would start. ...

47 views with 2 answers (last answer 2 months ago)
johnyappleseed
0

Bronco 2 Wont Start

Got my bronco stuck in deep water and mud today. Put logs in ruts and managed to drive out. Shut it off probaby 10 times during and after no problem. Drove 20 kms home parked and shut it off now it ...

45 views with 6 answers (last answer 2 months ago)
dpino
0

I Have A 1986 Ford Bronco 2 4x4 Eddie Bauer. After I Get Past 45 Mph & Pres...

1986 Ford Bronco 2 4x4 Eddie Bauer *Please see above question* Thx

83 views with 3 answers (last answer 3 months ago)
WunCrazyInjun
5

"t" Model Automatic Transmission

I have a 1990 Bronco II w/ "T" code Automatic Transmission, is there a difference between the floor shift and column shift aside from the obvious and are they interchangeable?

carjl11
0

1990 Bronco Ii 2.9 Fuel Injection. Used To Start Right Up. Got Harder To St...

Checked oil and was over full mark a lot and thin. Had been 1/8 in. above full mark. Drained over a qt. out and still 1/2 in. above mark. No water in oil and no water loss from radiator. No other flui...

108 views with 2 answers (last answer 3 months ago)
bruceray
0

Procedure For Replacing Dist. Cap On Fuel Injected 2.9

what needs to be removed to replace my cap and rotor on fuel injected 2.9 v6.

1 2 3 4 5 ... 7 next

Favorite this topic

Subscribe to Ford Bronco II questions.

Search Ford Bronco II Questions

Ford Bronco II Experts

#1 Colin Rivet
Colin Rivet
Reputation 190
#1 Andrew Olsen
Andrew Olsen
Reputation 190
#3 tennisshoes
tennisshoes
Reputation 170
View All