Chevrolet S-10 Questions Maintenance & Repair
Truck Dying
I have a. 2000 s10 2.2 standard truck.about 6 months ago it died while I was driving for the first time.happened sporadically and I noticed that if I was under a half of tank of gas or if it was ...
What O2 Sensor Should I Change ?????
I went and got a e-test today and failed. I was woundering if anyone can make sence of it : Under Systems Monitored it says Misfire (Ready) Fuel system (Ready) Comprehensive Components (Ready) Catalys...
2001 S10 Starting Problem
My 2001s10 will not start in less you hold it to the floor and let it turn over tell it starts and then it won't stay running long put new fuel injectors in it new plugs new wires new crank shaft s...
O2 Sensors On A 1999 Chev S10
location of the o2 sensors
'03 S-10 Blowing Off Fuel Line
Why does my '03 4.3L 5spd 4x4 S-10 blow the fuel line off at the front of the in-line filter? Connector and clip look good and feel secure until I try to start it; then it blows off.
Brake And Driver Side Turn Lights Don't Work And Keeps Blowing Fuses
1991 s10 4.3 4x4 drivers side turn light and brake lights aren't working and now it's blowing the turn signal fuse
Chevy S10 06
So the fuel pump and filter have been fixed cause that's what the read was on it from auto zone. However it will only run for maybe 5 mins and truck will die???? What are some suggestions!??? Ple...
I Have A 2002 Chevy Blazer S10 LS
rough idle at times , it seems to work better when the ac is on . in the morning cranks a little hard .
So I Have A 91 Chevy Ive Replaced The Following
so I have a 91 chevy ive replaced the following, injector, fuel pump, fuel pump relay cap rotor plugs and wires the truck is still not running it cranks and back fires what could it possibly be
Random Miss Fire
I have a 99 s10 4.3 i have replaced cap rotor wires coil maf map egr gasket throttle position sensor the problem will go away for a bit when i replaced something but would eventually come back what...
Transmission
So I have a 91 s10 standard cab long box with the 4.3L and 4wd I also have a 86-87 standard cab long box 2wd with the 4.3L and I just swap transmissions? If you guys could help that would be great
I Have A 95 S10 2.2 4 Cal And I Have Put Everything On It And Today I Put A...
The new parts I put on it already are a new fuel pump, spark plugs, starter,coil packs, crank sensor and ignition control module....
S10 Rod Bearings
Can u get an oversized rod bearing for a 4.3 in a 97 S104x4
Pittman Arm Replacment
2000 model S-10 V 6. Is it possible to replace the Pittman arm using a puller without removing the gear box from the truck. If so are there any specifics that need to be known before it's removal.
Wontvstart
My fiance s10 won't start for a while he it theclutch , what caused that?
High Oil Pressure
106k miles immediately after replacing head 9yrs ago my pressure tops out when driving but goes to 60-75% when idling. The car runs fine, its only driven when other cars are being repaired so only...
Rear Turn Signal Stopped Working, But Only Under Load
At least, that's how it started: Every time I put in a full load of wood chips, the right rear turn signal would stop functioning, and when I emptied the bed, it would work again. That kept up for a...
87chevy R10 Was Running Turn Lights On Shut Down Wont Start
Hi my 87 Chevy r10 was running out in drive went couple feet turn my lights on and it slowly lost power and died. Try to start it it cranks but won't fire up
Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use. Content will be removed if CarGurus becomes aware that it violates our policies.