After wiring harness replacement

Asked by Guru95JSHQ Jan 21, 2021 at 11:59 AM about the 2000 Oldsmobile Alero GLS

Question type: Maintenance & Repair

I have a 2000 alero. I had to replace the main fuse box and wiring harness
back to the two cabin fuse panels. Now when I turn the ignition to the on
position. I don't hear the fuel pump kick in. Do I have to leave the ignition in
the on position for ten min? Or is the key even chipp?

1 Answer

26,810

This is passkey module relearn. I don't know if it will help? with this system, the key doesn't have a pellet or transponder, it's the key cylinder that communicates with security system. It's just a normal key. Did you check for voltage to fuses? Some fuses hot all the time, some go hot with key on. Grounds are all good? I thought passlock was just fuel injector disable. I didn't think it would effect initial prime with fuel pump? good luck

Your Answer:

Own this car?

Share your experience with others.

2000 Oldsmobile Alero

Review another car

CarGurus Experts

  • #1
    TheStern75
    Reputation
    940
  • #2
    sun4shine2006
    Reputation
    720
  • #3
    Guru7Q4N
    Reputation
    580
View All

Know more, shop wisely

Search

Used Cars For Sale

Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use. Content will be removed if CarGurus becomes aware that it violates our policies.