my gas hand doesnt work how can i fit it

my gas hand doesnt work how can i fit it 1 Answer

I have a 90 D21 pickup 5 speed 2x4. My problem is that it will crank, run idle and I can rev the engine but when I put it into gear it lose power, won't go 2 Answers

When I put my truck in gear it loses power and shuts off. I have redone my timing chain, replace my exhaust, tune-up, mass air sensor, O2 sensor, fuel pump and filter, and distributor. I still have th...

truck starts and idles fine. the moment I touch the gas it dies. 7 Answers

My truck has had a few problems lately. First started with running fine but sounding like a miss and intermittent idle speed. decided to change ignition, cap, rotor, wires, plugs. ran much better o...

Truck stalls out giving it gas you had off it gain speed and Power I won't go no faster than 40 miles 2 Answers

I have a stalling out problem giving my 97 Nissan 2 wheel drive gas stalls out about 40 miles won't go no faster than unless you let off the pedal then it will gain speed and a little bit of power ...

I have a 85 Nissan. It cranks and idles ok, but if I give it any gas it sputters and dies. 7 Answers

I wouldn't think it was a relay since it does start, nor the fuel filter since it just started doing this all of the sudden. I have access to a fuel pressure tester, but will I have to drop the tank ...