My mazda 3 2004 2.0l is stalling when I goto turn it on it takes really long to turn over then when it's on it will idle idle idle boom shut off start it again start driving come to a stop idle idle then shut off

My mazda 3 2004 2.0l is stalling when I goto turn it on it takes really long to turn over then when it's on it will idle idle idle boom shut off start it again start driving come to a stop idle idle then shut off 2 Answers

2007 Mazda 3 Replaced Thermostat Now Cool Air on Idle 1 Answer

2007 Mazda 3 - Threw a CEL - (P0128 - Coolant Thermostat (Coolant Temp Below Thermostat Regulating Temperature) Fixed CEL by Replacing Thermostat - I Flushed Coolant and Replaced Thermostat - ...

my air conditioner never really blows cold. it seems to be only cool then it will get warm no matter how high i turn it up then cool then hot .i just charged the ac system no change 1 Answer

bad bearing sound at starts at belt sound leaves 1 minute later ac is mildly cool then hot then cool . it really only gets cool when i first turn it on jhust charged didn't help

Rough Idle on Mazda 3 2006 Hatchback 2 Answers

My Question: Is it the Passenger Motor Mount, the throttle, the EPA Solvenoid, the Rear Motor Mount or something else? Last week I took a rough slide on some dirt road and then the bottom of my car...

Help. I bought a Mazda 3 Sport GT 2011, fully certified but it seems like the low beams don't work. I have 3 settings, no lights, daytime running lights, and high beams. Is this right? The car manual seems to suggest this too, but when I put the lower setting on, everyone, including police tell me I need to turn lights on, and when I turn the high beams on, I piss everyone off (and the police try to give me a ticket). Is my car screwed up, or is it made this way? Thanks! 1 Answer

2011 Mazda 3 sport, GT, Hatchback. Either I have weak daytime driving lights (and everyone tells me I need to turn lights on) or I have full high beams...is this right?