Brake pressure

Asked by Glenn May 30, 2019 at 05:01 PM about the 1986 Chrysler Fifth Avenue Base

Question type: Maintenance & Repair

I have 86 Chrysler fifth Ave,my problem
started right after I replaced the front brake
pads. I'm not getting no pressure when I try
to bleed the system. I changed the rear
brake lines, wheel cylinders both sides and
rear pads. New master cylinder,brake
booster and proportion valve, still no brake
pressure at all need help. the only thing I
didn't change was the front calipers an
rubber hoses.

2 Answers
10

Eagle1Co answered 4 years ago

Did u bench-bleed the new master before installing? This problem can only be caused by 2 things: air in the system (likely in the master cylinder if not properly bled 1st) or a leak somewhere in the system.

1 people found this helpful.
Mark helpful

Glenn answered 4 years ago

Yes the master cylinder was bench bleed before installing,I'm thinking my new proportion valve needs the special tool when I bleed the system. very little fluid come out when I do the front brakes, back one's flow very hard over the rear differential

Mark helpful

Your Answer:

Related Questions

  • Brake pressure 2 Answers

    I have 86 Chrysler fifth Ave,my problem started right after I replaced the front brake pads. I'm not getting no pressure when I try to bleed the system. I changed the rear brake lines, wheel cylin...

    1986 Chrysler Fifth Avenue Base

    -

    Maintenance & Repair

  • I need help with electrical/fuse problems can anyone please help? 5 Answers

    I have owned my Chrysler 86 Fifth Avenue for quite some time now. The headlamps work after installing new ones. I refuse to drive any other vehicle but this one. Now the hazard lights, the rear brak...

    1986 Chrysler Fifth Avenue

    -

    Maintenance & Repair

  • Jerking and vibration upon acceleration??? 1 Answer

    i have a 1987 model 5.2 rwd, and upon acceleration the car jerks, and vibrates hard depending on how much throttle is bieng applied, especially from a stop the car vibrates, and jerks then sometimes s...

    1987 Chrysler Fifth Avenue

    -

    Maintenance & Repair

  • No spark 1 Answer

    Car Will turn over but has no spark

    1992 Chrysler Fifth Avenue

    -

    Maintenance & Repair

  • Headlights-- 1 Answer

    Our 1988 5th avenue does this: on high beam both the high and low beams are on on the driver's side along with the high beam on the passenger side, but on low beam the lights on the driver's side do...

    1988 Chrysler Fifth Avenue

    -

    Maintenance & Repair

Own this car?

Share your experience with others.

1986 Chrysler Fifth Avenue

Write a car review

Review another car

Shortcuts

Search Chrysler Fifth Avenue Questions

CarGurus Experts

  • #1
    Ed Morgan
    Reputation
    90
  • #2
    Mathieu Caron
    Reputation
    70
  • #2
    alicat3373
    Reputation
    70
View All

Know more, shop wisely

Search

Used Cars For Sale

1987 Chrysler Fifth Avenue Base For Sale
1 listing

Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use. Content will be removed if CarGurus becomes aware that it violates our policies.