Cyl. 2 missfire

Cyl. 2 missfire 2 Answers

I have replaced coils wires plugs and injector and still have a miss all started after I gutted the cat what next plug is wet from fuel but I have spark u think maybe control module or fuel pump ma...

will a ser. 2 4x4 shifter cable work on the ser. 1 system 2 Answers

dealer said the ser.1 cable is 153mm. long & the ser. 2 cable is 180 some mm. long but the ser.1 cable has been discont. but he said he could not tell me if the ser.2 cable would work in place of the...

I installed a fuel pump on my 2002 GMC Sonome engine 4 cyl. It started righd not startet up. But, after driven 2 miles, stalled out and died. Since then I could start only after taking out pump out of tank and reinstalled. Oil pressure is more than 40 PSI. I can not find any voltage from terminal.. I put a hotwire (jumper) from 87 terminal to 30 Terminal in fuel pump relay terminal, still no juice. I put a wire from batter to straight to pump . The new pump made noise . Still could not start. In this morning I put a jumper from 87 terminal to pump. I managed the engine running. I could start without jumper about 5 times. While the engine running, I decided to take my truck to road test. Whiel the engine running, I was gathering some tools and equipment for in case of broke down, the engine shut off. Why does my truck do this? I need help, please. 3 Answers

I installed a fuel pump on my 2002 GMC Sonome engine 4 cyl. It started righd not startet up. But, after driven 2 miles, stalled out and died. Since then I could start only after taking out pump out of...

Engine temperature fluctuation (4 cyl) 7 Answers

Started off my commute this morning in a cold Floridian 50 degrees F and a cold engine. Ten minutes into my commute my engine temp gauge showed a 250 degree F reading.The temperature fluctuated betw...

Installation of 22in rims on a 2000 GMC sonoma pick up, 2 wheel drive 1 Answer