i put new pluds and wires on a 2003 ranger 2.3L it ran for a day now it will not start

i put new pluds and wires on a 2003 ranger 2.3L it ran for a day now it will not start 2 Answers

I have a 1990 ford ranger 4x4 2.9 liter v6. It had set for a couple years and i got it and i have put everything fuel related on it new! And now i can drive it until it gets warmed up good and it will 6 Answers

It will die on me after its warmed up good and will turn over but wont start but i can let it set for a while and it will start up and do the same thing.(oil pressure hand jumps around) i was thin...

I have a no spark condition on my 98 ford ranger. Started it on day and it ran for about 2 seconds then died. Wouldn't restart ckecked for spark and had none. 1 Answer

I check all fuses and relays. All good there.I replaced the front coil pack as the connector had broken off. no fix there. I switched the packs around still no spark. I replaced the crank shaft sensor...

i have a 1990 ford ranger 2.3 liter the 8 spark plug and it will start up fine then i will drive it for about 5 mins and then it will run bad 4 Answers

1990 ford ranger 2.3 liter the 8 spark plug and it will start up fine then i will drive it for about 5 mins and then it will go to spitting and sputtering and backfiring and when you give it gas it ...

I have a 94 ford ranger it turns over but will not start 2 Answers

O.k. I drove it to work it drove fine then on the way home it started sorta chugging so I put gas in it cause the gas was low it started fine then I got home turned it off came back a few hours l...