Your Answer:
Related Questions
-
I have a 2012 ford escape XLT. when the engine is hot and up to temp the radiator reservoir tank is cold. the lower hose in front as well as the upper hose going back to the over tank does not seem to get hot as well. I was wondering if I have a bad thermostat or water pump or both. 1 Answer
2012 Ford Escape XLT FWD
-
Maintenance & Repair
-
My 2008 Ford Escape AWD floor matts keep getting soaked. I thought I had fixed it by making sure the sunroof was closed properly, but it has continued. I have tried to figure out where this is coming from and finally after drying them out again I laid under the the vehicle and both on the drivers side in the middle of the front floor area and the passanger side there is a small hole about the size of a dine right in the middle. That would account for the water coming in after rain storms and such, but why would these two holes be there? Was there a drain area there with plugs and they are missing? Can I have a piece of metal welded over them? Don't know why they would be there. Doesn't seem to be a rust issue as it is frim all around these small holes. 7 Answers
Water leak on floors from underneath. There is a small hole size of a dime on both drivers side and passanger side underneath floor matts right in the middle of each. Can I have this repaired with a...
2008 Ford Escape Limited AWD
-
Maintenance & Repair
-
My water pump, belt and thermostat recently was change due to the pump locking up, now the heat gets really hot when the RPM's is over 1500 but cold at idle. What could be wrong? 2 Answers
2010 Ford Escape Limited V6 (3.0) AWD
2010 Ford Escape Limited AWD
-
Maintenance & Repair
-
I have an 05 escape 3.0 in moring when starting it it will putter and die first time 2nd time will start right up if i am stopped to long at a light or sign sometimes when i press the gas it does nothing let of gas press again it will go 4 Answers
I have an 05 ford escape 3.0 in morning when starting it it will putter and die first time 2nd time will start right up or sometimes i need to give it gas or it will putter and die again. If i am sto...
2005 Ford Escape XLT FWD
-
Maintenance & Repair
-
My 2010 Ford Escape will blow cold air for about 3 seconds when the AC is turned on. I checked the compressor and the clutch will engage for those first couple seconds and then stop completely. I thought it might be low on freon, but when I went to check the low pressure, I got a low pressure reading of 100, which is way too high. My guess is the relay is done or maybe the compressor. Any advice? 1 Answer
My 2010 Ford Escape will blow cold air for about 3 seconds when the AC is turned on. I checked the compressor and the clutch will engage for those first couple seconds and then stop completely. I ...
2010 Ford Escape XLS FWD
-
Maintenance & Repair
Own this car?
Share your experience with others.
2012 Ford Escape
Shortcuts
Search Ford Escape Questions
CarGurus Experts
-
#1BrattsReputation4,460
-
#2Gene ArnettReputation3,990
-
#3KenFReputation3,600
Know more, shop wisely
SearchRelated Models For Sale
Used Cars for Sale
Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use. Content will be removed if CarGurus becomes aware that it violates our policies.