i have a 1999 concord and i replace the blower switch and it work good,now it only works on high speed

i have a 1999 concord and i replace the blower switch and it work good,now it only works on high speed 1 Answer

1998 Chrysler Concorde wouldn't shift properly, ran at high rpms and the spedometer would read 80 mph even when I was only going 45.Replaced the input & output sensors and now can't get car to move. 2 Answers

My 1998 Chrysler Concorde wouldn't shift properly. I'd get to 45 mph and it wouldn't shift. It was running at high rpms and the spedometer started reading about 80 mph. I replaced the intake and ...

blower motor problem 1 Answer

My 1999 Concorde has a problem with the heater blower motor.It only works on the highest setting.Ive reseached the blower motor resistor and plan to test/replace it. I have priced these around $40 or ...

The malfunction indicator light came on (OBD II) and the car started running as if it were misfiring. It only has 50,000 miles on it. I checked the tranny fluid and it was ok. What else can I check? 2 Answers

Yesterday for the very first time, the OBD II light came on my panel. When I first started my car it was running very rough, even at idle. I wasn't sure what the light was and pulled over to see, th...

, "1996 Chrysler Concorde #14... 5 amp fuse burns out every time it is replaced on cruise message center. hvac fan blower not working but a/c compressor does work also speedometer, tachometer, fuel & temp. gauge not working all problems started at same time. air bag light working. Tried new ignition switch still blows fuse. 1 Answer

"1996 Chrysler Concorde #14... 5 amp fuse burns out every time it is replaced on cruise message center. hvac fan blower not working but a/c compressor works also speedometer, tachometer, fuel & temp...