hi i have 2005 ford ranger 2.3 standard with key in run postion push cluthe to floor motor turns over any ideas?

hi i have 2005 ford ranger 2.3 standard with key in run postion push cluthe to floor motor turns over any ideas? 1 Answer

2002 Ford Ranger 2.3 to 5.0 Engine Swap motor mounts 4 Answers

1999 Explorer 5.0L engine going into a 2002 Ranger. Currently, the ranger has a 2.3L. Need to know if the original motor mounts from explorer will fit directly into the ranger.

I have a 94 ford ranger it turns over but will not start 2 Answers

O.k. I drove it to work it drove fine then on the way home it started sorta chugging so I put gas in it cause the gas was low it started fine then I got home turned it off came back a few hours l...

89 ford ranger 2.3 engine misses with alternater plug in 1 Answer

engine only misses when alt is plug in

I have a 96 Ford ranger, 4 cylinder manual and have a problem I can't figure out. I can start the truck every time with no problem it isles great and I can sit there and rev it all day no problem but if I go to drive it I can make it about 1/2 mile and then that's it, ill press the gas petal and it won't do any thing but kill the gas (no gas) but soon as I take my foot off the gas it will idle just fine and rev fine but won't go anywhere unless I let it sit for a few mins and it will start all over. I have replaced the IAC, TPS and today the external fuel filter that was clogged but same thing. Once in a while if I push the clutch in it will stay at a rev for a sec. Please help 5 Answers

96 Ford ranger need help :(