How to install fuel pump on 1994 eldorado touring coupe with 4.6
2 Answers
You have to drop tank to do this,start by removing as much gas from tank as you can.Next jack up back end of car,and support it good for your safety.Then there are two straps on tank,you must remove them.have a jack or a buddy help,you lower tank down,after you have tank down,You will need to bleed the fuel line from pressure,the best way to do this is the wire ,s running to fuel pump,unhook them and turn engine over a few round,s to relieve pressure from line,s.After that,there is a ring,with little lips,take a flat screw driver on the tips and hammer and tap it around to remove,after you remove ring,you can pick pump up out of tank,and replace with new one.Repeat backwards to install ,,,Good luck with it.
I have a 1993 ETC. I looked under the rear of the car and I see, 2 exhaust pipe's, a metal plate inside of each exhaust pipe w/,gas tank inside all of this. R u sure all I do is loosen tank straps and drop tank?