I needto replace my 2001 camry alternator. Got old one out, but new one seems too big for bracket to go in?!? How do I get it in?

I needto replace my 2001 camry alternator. Got old one out, but new one seems too big for bracket to go in?!? How do I get it in? 4 Answers

I got a new battery for my Camry. I understand that this resets the ECU and it will take a little while for it to reprogram itself, but I may have an alternator issue too. 13 Answers

When I start my car, by jumping it, the idle speed is too low, so the engine shuts off if I am off the throttle for even a second. It's a manual, so it's tricky (if not impossible) to get the car to ...

My 2000 v6 toyota camry turns on but just for a second and goes off right after it goes on. Only when is hot. In the mornings generally it turns on fine for like 15 minutes. Some said to check the fuel pump, and alternator, but they are fine, i think it has to do with the plastic connectors that go in to the camshaft position sensor that are falling apart for so much heat on the sidesn and an electritian man did a new one just the ends so it would connect the sensor tightly, but is going off when the car is on after 15 minutes or so. What should i do? replace the sensor? i can´t find the original connectors 2 Answers

electrical issue i think

I installed a new stereo in my 2004 Camry, but something cause my dash lights to burn out. I found the fuse and replaced it but it didn't turn on the dash lights. I beleive it has something to do with the wiring but I can't figure out what needs to connect with what. Has anyone every installed an after market stereo in a 2004 toyota camry? 2 Answers

I found the fuse for the dash and glove box and it was burnt out so I replaced it. The glove box light came back on when I changed the fuse, so I know it's more than the fuse. Also someone on here m...

I am trying to replace the 2 multi fuses in my 2012 Camry. What is the trick to get them out? 3 Answers

All the fuses are blown and I need to replace them. I have the entire fuse box loose but cannot figure out how to get to the bolts holding them in