How to get an error code
What does it mean if the check engine light stays
on & doesnt flash at all. I have a 94 toyota camry
xle v6 3.0L , I connected a wire to E1 & ET1 then
turned car to"on" position but the engine light still
stays on without flashing at all, ive taken it out &
putting it in as far as it'll go thinking it wasn't
connecting but no matter what i do our how many
times i try, im still not getting it to flash, any info
would be great thanks, Jessy
Why are you attempting to flash codes? Is there an issue with this vehicle?
Is this correct?
Or this?
One more time. I think I have the correct one.
Which do you have? No Flash...no Codes stored.
On the 1994 Toyota Camry with the V6 3.0L and the A541E automatic transmission.... the car was ahead of its time and actually does have a OBD II port that you can use to get codes from. The OBD I under the hood and below the lower drivers side dash will only work on the 4 cylinder engine(as seen in the diagrams above). For your specific Camry, to the left of the steering wheel is a small compartment. Like a small change tray... pull that tray completely out of the dash and the OBD II port is behind that next to a small fuse panel. I will include a bad picture of the port, after the tray is removed... sorry my cell is low resolution.
I don't have answer but would like to know which ports to bridge
