I have 1991 M_B 300SL Started replaced, all barrety termal tighten, what now?

Asked by kelleyfalm6263 May 05, 2012 at 09:29 PM

Question type: Maintenance & Repair

whenI tryed starting, only got clicking from started, then it happen again turned key nothing, garage checked battey, replaced started, started still wont start the car , what schould be done now?

1 Answer

199,835

Check neg. cable connection on engine block. If ok check sylnoid wire to starter is getting voltage when key turned to start position. If none will probably be an issue with ign switch. Mine does same at times but if I wiggle key up and down while in start position it will turn over. my ign needs to be replaced. Also might want to check clutch switch if it not working will do the same thing. Hope this helps

1 people found this helpful.
Best Answer Mark helpful

Your Answer:

Own this car?

Share your experience with others.

CarGurus Experts

  • #1
    Gene Arnett
    Reputation
    245,030
  • #2
    Rowefast
    Reputation
    183,620
  • #3
    dandyoun
    Reputation
    169,310
View All

Know more, shop wisely

Search

Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use. Content will be removed if CarGurus becomes aware that it violates our policies.