If you can, try and re-use the connector at the end that connects the wire to the switch. Splice the wire by twisting the bare leads together and soldering them or crimping a splice connector to the ends. In either case be sure no exposed wire remains after splicing. Use electrical tape or heat shrink tubing to prevent any shorting after the splice is made.
Wires broke on the switch
Ford Explorer
-
Maintenance & Repair
Yes can you tell me ware the oil switch cage is located on here thank you
1998 Ford Explorer 2 Dr Sport 4WD SUV
-
Maintenance & Repair
Where is the fuel reset switch in a 1994 Ford explorer at
1994 Ford Explorer 4 Dr XL SUV
-
Maintenance & Repair
Driver ajar door switch was replaced, with door open bell is still buzzing. But after it’s closed it goes off. Is there something that tells the system there’s a key in the ignition. A warning ...
2003 Ford Explorer Eddie Bauer V6 4WD
-
Maintenance & Repair
I have a 2003 ford explorer 8 cylinder. 8 months ago. My break light would not go off. I went to the junk yard and got a used break light switch. It worked for about 3 months. Now its malfunctioni...
2003 Ford Explorer Limited V8 4WD
-
Maintenance & Repair
Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use. Content will be removed if CarGurus becomes aware that it violates our policies.