My 1989 gmc 1500 pickup had a meltdown at igmiton switch.i need to hotwire it to get it home...i need quickest and shortest way to do this..cant let it sit on freeway

My 1989 gmc 1500 pickup had a meltdown at igmiton switch.i need to hotwire it to get it home...i need quickest and shortest way to do this..cant let it sit on freeway 1 Answer

Hi. My 1996 gmc sierra 1500 I was driving down the freeway and truck died. A couple minutes later it would start. I got home turned it off and it won't start. Got fuel up to the throttle body 2 Answers

Changed filter and regulator And pump is running. Starting fluid or gas in throttle body will start and run til it's gone. Help! Please

i have a 02 gmc sierra 1500 extended cab, 5speed manual tranny. the rear main transmission seal is worn out and i want to replace it myself. need acvice on removing seal 3 Answers

i need some advice on proper way to remove bad seal and installing new one. i have done this once before on the same truck and it had minor leak in it since so i dont want that to happen again. ive...

04 gmc sierra 1500 5.3 died on me on the highway got it towed home starting going at it, hooked two different scanners to it and not throwing any codes (ecm is working bc the map was reading correctly but also the rpm was zero) anyways checked fire none checked injectors they wasnt working either(built fuel pressure then unplugged fuel relay then turned engine over and the pressure stayed the exact same) i assume it might be the crank sensor but i would think it would throw a code, anyways came back this morning and before doing anything for the hell of it i checked the gas cap and tightened it and it fired up perfect three different times and the last time i let it run and it died after bout 45 seconds (fuel pressure reads 55) and after it died its doing the same thing cranks but wont fire or start 1 Answer

died on me on the highway got it towed home starting going at it, hooked two different scanners to it and not throwing any codes (ecm is working bc the map was reading correctly but also the rpm was...

I have a 1989 350 5.7 TbI and I have a 96 GMC 1500 with a 305 5.0L Vortec with over 250,000 miles can I use the the heads from the Votec 305 5.0L on the 350 5.7L TBI? If so should I change the cam if so what do you recommend this is gonna be a show/driver what kind of cam and lifters do you suggest and what all do I need to do the heads (valve job, replace lifters, rockers) and what should I do to the block seeing that it only has a few miles since rebuild 3 Answers

I have a 1989 350 5.7 TbI and I have a 96 GMC 1500 with a 305 5.0L Vortec with over 250,000 miles can I use the the heads from the Votec 305 5.0L on the 350 5.7L TBI? If so should I change the cam ...