98 TA WS6 5.7 starts then stalls after 3-4 secs

Asked by SickLS1 Sep 15, 2015 at 03:02 PM

Question type: Maintenance & Repair

I have a 98 TA Ws6.  Headers, F.a.s.t throttle body, SLP 3" exhaust, LS6 intake, motor is 2001 Vette.  PCM is 2001 computer. Harness rewired for 99 and up.
Was throwing code P0340: "Camshaft Position sensor "A" circuit High Bank 1 or single sensor" . Then, traced all wires though harness from cam sensor to pins (wires) in PCM, Found a wire in wrong pin in connector, fixed and it starts rite up now but stalls after 3-4 secs. Also replaced two o2  sensors and cam position sensor. Now, no codes, but still starts and stalls! Also replaced fuel pump. Replaced "crank" pos sensor also.

2 Answers

70,095

hummm sounds like something is loose...so did you fix the code? remove battery cable/clear code ..does it have the same code or a different one after you re start it in that 3-4 seconds..

sorry getting back to you so late, I'm doing this while at wrk. cleared code, the try starting, and no codes come up

Your Answer:

Own this car?

Share your experience with others.

CarGurus Experts

  • #1
    tenspeed
    Reputation
    16,820
  • #2
    james sparrow
    Reputation
    14,420
  • #3
    John Saffrahn
    Reputation
    12,430
View All

Know more, shop wisely

Search

Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use. Content will be removed if CarGurus becomes aware that it violates our policies.