Looking for a Used Corvette in your area?
CarGurus has 10,855 nationwide Corvette listings starting at $3,499.
Average User Score
4.5 ⁄ 5 stars
Based on 23 reviews
1990 Chevrolet Corvette Overview
Overall User Score
Based on 23 reviews
The 1990 Chevrolet Corvette is best remembered as being the base model for the new ZR-1, the "Super Corvette." After many production delays, the ZR-1 was released at a price hovering around the $60,000 mark, almost twice the sticker price for the base model. Dealers were rumored to be getting over 6 figures for some of these cars.
And what did consumers get for their double-Corvette price tag? The 3,049 owners lucky enough to be able to buy one received an all-new drive train; the all-aluminum 350-ci LT5 V8 went from 0 to 60 in 4.3 seconds and was rated at 375 horsepower. It was available only as a coupe, and had a wider tail section and wheels than the base model.
The base model for that year was a 5.7-liter 350-ci V8 rated at 245 horsepower.
What's your take on the 1990 Chevrolet Corvette?
Chevrolet Corvette Questions
1990 Corvette Horn Problems
bought a 1990 vette recently, and discovered no horn.have a couple of manuals, but not much mentioned on the horns. can't locate any fuses or relays related to them. are there any? or just hard to fin...
Hello Again , Getting Ready To Change My Thermostat In My 1990 Corvette C-4...
THIS IS A GREAT FORUM, AND BEEN A BIG HELP ALREADY..... THANKS!!!
Power Antenna Mast Kinked
HAVE A 1990 VETTE WITH A PRETTY GOOD KINK IN THE MAST. MOTOR OPERATES FINE AND GOES UP, BUT WON'T GO ALL THE WAY DOWN, FROM THE BEND DAMAGE. CAN THE MAST ONLY BE REPLACED ? OR, IS IT BETTER TO CHANGE...
I Have A 1990 Corvette.i Went Thru A Puddle Of Water Last Week And When Thi...
Well I can drive it about 3 miles before it acts up.I thought it might be fuel injectors but that would not wait 3 miles before it starts like starving for fuel
I'm Going To Change The Antifreeze Out In My' 90 L-98 Coupe. Any Special Ti...
Recommended? Is a certain amount of water needed in system? I'm aware of using the GM type for the aluminum parts. Can't find any help, any input out there? Thanks Gurus....... Kmac, again.