Ford Bantam Questions Any type

  • Newest
  • Recently Active
  • Unanswered

Ford Bantam 1.3

I have ford bantam that wont start. After few secs the red lihgt next to the clock goes away but still wont start. Locksmith tested key for communication with computer box said theres communicatio...

Is It True That If You Want To Replace The Chain Of Ford Bantam 1.3 Rocam Y...

Time chain of Ford bantam how do you replace it took the engine out

My Rocam1.3 Engine Make Noise After Just Changing Top Gasket, Why?


Ford Bantam 2008 1600cc

I have a Ford bantam 1600 and it does not want to start in the mornings,the only way I get it to start is by pussing it,but if it first started it starts every time please give me advise ?

29 views with 1 answer (last answer 2 months ago)

Where Can I See Chassis Number On The Ford Bantam Body 2005 Model

seaching for chassis number of a ford bantam rocam 2005 model

Very High Refs

HI I would like to find out if its normal for a ford bantam rocam 2012 model to be at about 4000refs when you hit 120km/hour? My Bantam is using a lot of petrol and I would like to find out if thi...

Speedo And Odo Meter

My 2009 ford bantam xlt rocam speedo and odo meter just stop working, what could be the problem


Require A Fanbelt Routing Diagram On A Ford 1.3 Rocam Engine Without Aircon...

90 views with 3 answers (last answer 2 months ago)

Heat Sensor

Where on a Ford Bantam 1.6 2003 model can i find the heat sensor,it might be the problem for over feuling.

Why Does My Heat Gauge Sporadically Indicate That The Engine Is Over Heatin...

The heat gauge sporadically indicates the engine is overheating. The needle goes passed the red. This happens when I am standing in traffic or at a traffic light. Then the moment I start moving, the g...

25 views with 4 answers (last answer 2 months ago)

My 2004 Bantam 1600 Rocam Choke Does Not Switch Off Where Doi

Looking for the solenoid that controls the operation

6 views with 2 answers (last answer 2 months ago)

Ford Bantam Over Feuling

the dealer done diagnostics but can not find the problem. Black smoke when you start her up,sparkplugs flood and burn black and enjin run uneven. When you clean plugs she runs fine for a few days. Wh...

15 views with 1 answer (last answer 2 months ago)

Bantum 1.6 Fan Always Running Even If The Engine Is Not Running

the car doesnt start and both wipers and fan are running even if the engine is not running, without key in ignition also

Cold Start Problem, `automatic Choke Stuck

I have a 1600i bantam and it has developed a problem whilst being unused - it seems to have the automatic choke stuck open, so coldstart. The car idles but is extremely rich with black fuel smoke wh...

17 views with 1 answer (last answer 3 months ago)

The Plugs Can Make The Car Don"t Start

when i check the spark is okay the fuel is okay but it not pick up

15 views with 1 answer (last answer 3 months ago)

Do The Valves On A 1.3 Rocam Engine Bend When The Chain Breaks

bantam 1.3 rocam engine

68 views with 5 answers (last answer 3 months ago)

My 1.3i Bantam 2008 Breaks Down At High Revs

the car seams fine and when you drive it over about 3000 rpm it goes dead until you thake your foot of the accelerator and then its perfect below 3000rpm. the car was perfect yesterday. what could ...

16 views with 1 answer (last answer 3 months ago)

Does Not Start

hi, I have a ford bantam 2010 model, we found that the computer box was blown, I have replaced it but the car does not start, some of the lights on the dashboard goes on but not all,

27 views with 1 answer (last answer 3 months ago)
prev 1 2 3 4 5 ... 12 next


Search Ford Bantam Questions

Ford Bantam Experts

#1 Janus Welgemoed
Janus Welgemoed
Reputation 550
#2 Joel Mearns
Joel Mearns
Reputation 510
#3 MrRocket12
Reputation 460
View All

Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use.