Chevrolet S-10 Questions Any type
S10 Fear End
How d o I identify what tear end is in my 98 Chevy s10 2wd automatic
Cabin Filter
Where is it located
What Is The Role Of Vacuum Canister In Chevy S10? Can I Just Block The Vacu...
difficult to connect the vacuum line to the vacuum canister in my chevy s10 2001. I bleive the nipple athe connection site is broken?
Service Engine Light Flashes, Sometimes Hard To Start
engine runs rough and dies sometimes reversing then to drive
S10 Crank No Start
97 s10.was driving fine.stop at store start back up.back out and just died..try to start,but just cranks...sprayed carb start in air filter hose started up but died...turn key to cycle can hear fue...
Sputtering Backfire - Chevy S10 With A Blazer 4.3 V6 Engine
Hi guys, I have a 1994 Chevy S10 that has a 2002 Blazer 4.3 V6 vortex Engine in it. This morning on the way to work as I was going up an on-ramp (uphill) to get on the highway, the truck began to sp...
Chevy S10 Problem
I had to change the alternator an I forgot to unhook the battery before I took the cables off the alternator now the truck has nothing I changed the battery an the alternator an checked the fuses ...
My 2004 4.3 Engine Is Constantly Overheating
When the truck idols, its fine. when driving the temp needle goes above 210. heat comes down to the floor board that almost scalds your feet through your shoes. if i turn on the AC temp really shoot...
Fuel Pump Interchange
What year and kind of truck fuel pump will interchange with a 1996 Chevy S10 4wd with a 4.3
Temp Gage
Temp gage flipped all way down to oil gage reading 40 on oil gage..
Oil Leaking From Driver Side No Oil Registering On Dipstick?
Oil pressure has been sitting little less than 40. The space where drivers front tire is at is completely covered and dripping with oil.
2003 S10 Motor Swap
I have 2003 S10 4.3 TBI with a blown motor. Im putting in a 2006 4.3 MPI. My question is, will this make the computer throw codes and effect ability to run properly?
How Much Does The Maf Sensor Effect The Idle
4.3 vortec
How Can I Know For Certain That The Injector On My 2001 2.2l Is The Culprit...
Id replaced the injector and at first, my misfire had gone away. Slowly but surely, the engine would stumble intermittently, and know its misfiring completely. (cyl 3) With the eng. running, i canc...
Sparks Plug
I took down changed my bent valves set up everything and can't start. I checked the spark plugs and it ain't firing. What can be the possible reason??
What Are The Symptoms Of Bad Pvc
after tune up still have a slight skip. could pvc be bad
Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use. Content will be removed if CarGurus becomes aware that it violates our policies.