I changed rear wheel cylinder on passenger side, when started to bleed the brakes, and when pedal was to floor,,stopped running..will crank and run in 5 minutes..hit brake, dies again....

Asked by Jun 18, 2017 at 05:57 PM about the 1995 Ford Bronco XLT 4WD

Question type: Maintenance & Repair

2 Answers

905

Any cracks in line to brake booster? Check for a loose vacuum line concerning the brake booster or faulty check valve. Hoping this is not the brake booster itself. Good Luck!

No cracks in the line, can run for few minutes.....then shuts off again, like it may be getting hot....but its not hot....why would the engine shut off over brake cylinder? Ran fine, and no problems until I changed wheel cylinder....would that cause it? or something else?

Your Answer

Ford Bronco Experts

  • #1
    tennisshoes
    Reputation
    450
  • #2
    Js08016
    Reputation
    170
  • #2
    Clayton Cameron
    Reputation
    170
View All

Related Models For Sale

Used Ford F-150
3,304 Great Deals out of 224,486 listings starting at $1,200
Used Ford Mustang
601 Great Deals out of 39,958 listings starting at $1,895
Used Chevrolet Blazer
7 Great Deals out of 922 listings starting at $950
Used Jeep Wrangler
520 Great Deals out of 19,538 listings starting at $1,999
Used Ford F-250
447 listings starting at $2,500
Used Ford Explorer
1,264 Great Deals out of 70,146 listings starting at $1,000
Used Ford Ranger
196 Great Deals out of 5,574 listings starting at $995
Used Toyota Tacoma
722 Great Deals out of 45,869 listings starting at $2,500
Used Chevrolet Tahoe
829 Great Deals out of 42,143 listings starting at $1,987
Used Chevrolet Camaro
442 Great Deals out of 31,892 listings starting at $1,450
Used Toyota 4Runner
349 Great Deals out of 27,129 listings starting at $1,800

Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use.