Your car probably has a hydraulic clutch so look for a reservoir around the top rear of your engine bay along the fire wall. it will have a "fill to this line" mark or something similar on the side and a cap on top of it. If the fluid level is below the min fill line, add the recommended fluid into the top of the reservoir (the type is usually printed on the cap). Hope this helps.
Checking level
2003 Pontiac Vibe GT
-
Maintenance & Repair
I recently replaced the clutch in the car but seems that there is barely any clutch. The clutch engages way to low to the floor. I need to adjust that. Ive tried bleeding the slave cylinder still no...
2006 Pontiac Vibe Base
-
Maintenance & Repair
my frnt pass floor board and rearpass floorboard are wet.Whare does the fluid line run?
2003 Pontiac Vibe
-
Maintenance & Repair
Whenever I put the key in, and press the clutch and the brake pedal the car won't start until I have taken the key out and press the brake and clutch and put the key in several times. Why is it doi...
2004 Pontiac Vibe Base
-
Maintenance & Repair
The new switch is about half the length of the old one. I don't think the wiring harness will fit its connector. There doesn't seem to be any way to screw its bolt into position so that the clutch c...
2007 Pontiac Vibe Base
-
Maintenance & Repair
2003 Pontiac Vibe
Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use. Content will be removed if CarGurus becomes aware that it violates our policies.