Pulled off coolant hose and sprayed coolant everywhere.
Asked by Katelynn Sep 27, 2016 at 09:12 PM about the 2005 Mazda MAZDA6 4 Dr s Sport Wagon
Question type: Maintenance & Repair
i was trying to get to the throttle body on my 2005 mazda 6 s and when I
pulled off the coolant hose it sprayed hot coolant everywhere. After when I
flushed the coolant the engine light came on and pulled a code that was for
the purge valve. Could that be the reason for the light because I recently
purchased a new fuel filler cap but it was aftermarket. And so the light came
off and back on twice.
1 Answer
Your Answer
Related Questions
-
Pulled off coolant hose and sprayed coolant everywhere. 1 answer
i was trying to get to the throttle body on my 2005 mazda 6 s and when I pulled off the coolant hose it sprayed hot coolant everywhere. After when I flushed the coolant the engine light came on and ...
2005 Mazda MAZDA6 4 Dr s Sport Wagon
-
Maintenance & Repair
-
RPM goes down and the car shut off when slowing down or heavy traffic 2 answers
i have mazda 6 model 2006 when i slow down or at heavy traffic the car RPM goes down and sometimes the car shut off then i have to go to park and turn it on again normally when this happen the RPM is ...
2006 Mazda MAZDA6
-
Maintenance & Repair
-
I have a mazda 6 put new sencers in and reset the computer now the car has a problem stating then when i do get it started no power 1 answer
had the computer checked said a couple bad sencers replaced them. reset the computer by un hooking the battery for 5 min. hooked iy back up let car run 20min. then put air on for 5 min. turned off a...
2003 Mazda MAZDA6
-
Maintenance & Repair
-
2003 Mazda 6s V6. My swerve light and tsc light off turns on and I cant acclerate, 5 answers
This has been going on for about a month, if I'm driving I put it in Neutral turn it off and turn it back on, then its fine. Nothing seems to trigger it. It just randomly does it. Some days it wont do...
2003 Mazda MAZDA6 4 Dr s V6 Sedan
-
Maintenance & Repair
-
Mazda v6 2006 automatic trans. Died while driving and will not turnover. Battery and all electronics seem test fine. What can cause it not to turn over? 2 answers
Mazda 6 v6 2006 car died while driving. Will not turn over. Battery check and is fine. All electronics inside car seem fine too. What would cause it not to turn over? Turn ignition and nothing happens...
2006 Mazda MAZDA6 s Sport 4dr Sedan
-
Maintenance & Repair
Shortcuts
Search Mazda MAZDA6 Questions
Mazda MAZDA6 Experts
-
#1F_O_RReputation260
-
#2enginecreatorReputation230
-
#3Tom DemyanReputation220
Related Models For Sale
Used Cars For Sale
Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use.