have replaced all sensors since manifold was replaced still cuts off when at stop light
Asked by earlesookie Jun 21, 2015 at 04:25 PM about the 1999 Jeep Cherokee SE 2-Door RWD
Question type: Maintenance & Repair
replaced the manifold which had a hole in it afterward start running rough get to hot will
cut off replaces all sensors computor fuel pump plugs and wires crank and cam
sensors coil runs a little but after running for a while sitting at stop light seems to
wanna stall out take foot off of gas peddle will ram back up when manifold was replaced
was not setted on neddles correctly ramed up off scale resetted everything replaced
again
3 Answers
Your Answer:
Related Questions
-
have replaced all sensors since manifold was replaced still cuts off when at stop light 3 Answers
replaced the manifold which had a hole in it afterward start running rough get to hot will cut off replaces all sensors computor fuel pump plugs and wires crank and cam sensors coil runs a little bu...
1999 Jeep Cherokee SE 2-Door RWD
-
Maintenance & Repair
-
airbag light still on after a front collistion. All front airbags deployed and were replaced light is still on 6 Answers
My Jeep was in a front end wreck , all 4 airbags deployed. I replaced the four bags and the light is still on,also it says check airbags on the dash
2015 Jeep Cherokee
-
Maintenance & Repair
-
95 jeep Cherokee sport wont start. getting spark from ignitor, The fuel pump, fuel filter, distributor cap and button have all been replaced. It still wont start. Any ideas? 1 Answer
Had someone test the plug wires not getting a spark. These were just replaced in the spring. Thought it was the distributor cap. Please help if you have any ideas.
1995 Jeep Cherokee Country 4-Door RWD
-
Maintenance & Repair
-
Jeep grand Cherokee 2000 3.1 lt turbo diesel.Swings then starts up , runs for a few seconds and then cuts out.After cylinder heads was replaced,why is it so? 1 Answer
Jeep grand Cherokee 2000 ,3.1 ltr Turbo Diesel, swings then idles for a few seconds then cuts out, this after the cylinder heads were replaced with new, why is this so ??
2000 Jeep Cherokee
-
Maintenance & Repair
-
Oil gauge goes to all the way down to zero when I stop at light when I excelerate it goes back up to about 40? What can this be? 2 Answers
Oil gauge goes all the way down to zero when I stop and when I excelerate it goes back up to about 40, What could be wrong?
1997 Jeep Cherokee SE 4-Door 4WD
-
Maintenance & Repair
Looking for a Used Cherokee in your area?
CarGurus has 70,652 nationwide Cherokee listings starting at $1,450.
Shortcuts
Search Jeep Cherokee Questions
Jeep Cherokee Experts
-
#1swtcat13Reputation1,990
-
#2Daniel Guillen-PizzorniReputation1,760
-
#3Luis660399Reputation1,630
Related Models For Sale
Used Cars For Sale
Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use.