p0032 I replace o2sensor and light won,t go off what I do
Make sure the engine gets to normal operating temperature meaning a good thermostat. Also it may be the Temperature Sending Unit is faulty and should be replaced......P0032 JEEP - O2 Sensor 1/1 Heater Circuit High..... Possible causes; Faulty Heated Oxygen Sensor (H2OS), Bank 1 Sensor 1 Heated Oxygen Sensor (H2OS), Bank 1 Sensor 1 harness is open shorted to ground, Heated Oxygen Sensor (H2OS) Bank 1 Sensor 1 circuit poor electrical connection Heated Oxygen Sensor (H2OS), Bank 1 Sensor 1 circuit fuse Faulty Engine Control Module (ECM)..... Oxygen Sensors (O2S) or Heated Oxygen Sensors (HO2S) need to reach a minimum operating temperature of 750 degrees F to produce an accurate voltage signal. The faster the heated oxygen sensor reaches that temperature the faster the sensor will start sending an accurate signal to the Engine Control Module (ECM). In order to achieve the require temperature, a heater element is included inside the heated oxygen sensor. The ECM controls the heated oxygen sensor heater element based on signals from the engine coolant temperature and engine load. The ECM controls the heater element circuit by allowing current flow to ground. The ECM monitors the voltage signal received through the heater element circuit and determines the state of the circuit by comparing the voltage detected with the factory specifications.
Search Jeep Liberty Questions
Jeep Liberty Experts