Break lights not working

a multi tester would help find where there's power /ground and where there's not , the brake lights may go through the directional switch , the 3rd light works because it's not shared with the directional , everything needs a good ground

Above has it. Sounds like bad ground or bad hot wire.

I wire it to the top and mine is working I took a wire ran from top to right rear there is four wires tie into the black one

I had the same problem its a wire from the signal stack that comes loose just take off the plastic from the ignition its on top by the hazard light switch its you’ll probably see it

Well mine I had the problem after I hook up trailer si I was almost involved in accident I push the brake hard after that my brake lights went out so I check all fuses and wiring and everything was ok and I remove the brake switch and that was the problem is easy to fix one connector and one pin is above the brake pedal