- Home
- / Questions
- / Chevrolet
- / S-10 Blazer
- / I have a 89 s-10 4.3 blazer. It is cranking over but not starting. I can smell gas after trying to s...
I have a 89 s-10 4.3 blazer. It is cranking over but not starting. I can smell gas after trying to start it. I also put my finger under neath the injector and it had gas. I hear the fuel pump turn on.
6 Answers
T_S_T answered 3 years ago
Pull a wire from plug,or if eqipped with coil pack ,pull it,stick a extra spark plug in it or place a screw driver in it,ground it to motor and have some one turn engine over to see if you have spark.
T_S_T answered 3 years ago
Be carefull when you do this,make sure you are clear of wire,or it can bite you.
Your Answer
Related Questions
-
I have a 89 s-10 4.3 blazer. It is cranking over but not starting. I can smell gas after trying to start it. I also put my finger under neath the injector and it had gas. I hear the fuel pump turn on. 6 answers
i rebuilt the throttle body a year ago. I did not put a new throttle position sensor.
1989 Chevrolet S-10 Blazer High Country 4WD
-
Maintenance & Repair
-
I have a 1993 s-10 Blazer fuel pump fuse size 5 answers
I have a 1993 s-10 Blazer with the 4.3 liter Vortex under the hood. It is 4 wheel drive adn i keep blowing the fuse for my fuel pup. it has a 10 amp fuse put in the slot. Is that the correct size? I h...
1993 Chevrolet S-10 Blazer
-
Maintenance & Repair
-
I have a 1996 Chevy S-10 Blazer LS with 4.3 Vortec, Auto transmission and 4WD and I would like to know how can you tell if it came with a Flash Reprogamable ECC? 3 answers
I am trying to find out if my vehicle came with a Flash reprogramable ECC.
Chevrolet S-10 Blazer
-
Maintenance & Repair
-
can you put an erg valve upside down on 1988 s-10 blazer with 4.3 l engine 4 answers
I replaced the ERG valve on a 1988 S-10 Blazer with the 4.3 liter engine. it would barely run after I did this. I took it to a repair shop and they told me I put it on upside down. is this possible ?
1988 Chevrolet S-10 Blazer Tahoe
-
Maintenance & Repair
-
I am getting vibration from 25 mph to 55 mph in the drive train. When shifting to a lower gear going down a steep road I get a clunk. Sounds like U joints but they don't look loose. When I turn the drive shaft that is in front of the transfer case I hear a noise in the transfer case. Can U joints be bad but still appear tight? Can a transfer case be rebuilt like other components? 1 answer
I have a 1994 S10 Blazer. It is a four wheel drive with the push button selector. Last hunting season I noticed that when I was in 4 wheel drive and I shifted down to keep my speed down on the moun...
1994 Chevrolet S-10 Blazer 4 Dr Tahoe LT 4WD SUV
-
Maintenance & Repair

Looking for a Used S-10 Blazer in your area?
CarGurus has 24 nationwide S-10 Blazer listings and the tools to find you a great deal.
Shortcuts
Search Chevrolet S-10 Blazer Questions
Chevrolet S-10 Blazer Experts
-
#1carGrrlReputation1,780
-
#2Cody DoudReputation730
-
#3emtfirefighter77Reputation550
Related Models For Sale
Used Cars For Sale
Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use.