Inner toe-rod end
On the inner tie-rod of my 87
f150, passenger side, is a
metal bar that goes to
coupling of outer tie-rod. If it
is bent for adjustment and
not put in place properly ,
what is purpose of this?
The arm on thread side where it connects to coupling
Here is another pic, this arm was stright when I installed it. I had an alignment done and noticed this is now bent out. Why would mechanic do this?
You don't bend tie rods to adjust them.
They didn't bend tie rod, this is made on it at factory. I hope this pic shows. That was straight and between the clamp when I put it on.
