where is the 4 wheel drive module located on my 1988 Ford Bronco 2

Asked by Mar 01, 2015 at 08:15 PM about the 1988 Ford Bronco II Eddie Bauer 4WD

Question type: Maintenance & Repair

My 1988 Ford Bronco 2 will not engage into Four wheel Drive.

1 Answer

97,005

Above the heater box. Every once in awhile the GEM fails but it is not common, the most common failure is the transfer case shift motor, a simple test is to lightly tap on the motor while someone pushes the 4X4 high button, if it shifts into gear then the motor is bad, if not then you need to check the wiring, the first place to check is the section from the shift motor right up to the place where it goes through the floor.

1 of 1 people found this helpful.

Your Answer

Add photo

Related Questions

Search Ford Bronco II Questions

Ford Bronco II Experts

#1 tennisshoes
tennisshoes
Reputation 590
#2 Andrew Olsen
Andrew Olsen
Reputation 230
#3 Colin Rivet
Colin Rivet
Reputation 220
View All

Related Models For Sale

Used Ford Bronco
192 listings
Used Ford F-150
2,116 Great Deals out of 192,313 listings starting at $290
Used Ford Ranger
171 Great Deals out of 5,558 listings starting at $900
Used Jeep Wrangler
269 Great Deals out of 15,829 listings starting at $3,200
Used Ford Mustang
711 Great Deals out of 44,427 listings starting at $1,500
Used Chevrolet Blazer
1,180 listings starting at $1,495
Used Jeep Cherokee
352 Great Deals out of 40,267 listings starting at $1,500
Used Toyota 4Runner
231 Great Deals out of 19,230 listings starting at $2,195
Used Chevrolet Corvette
223 Great Deals out of 22,144 listings starting at $3,750
Used Chevrolet Camaro
357 Great Deals out of 31,258 listings starting at $2,500

Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use.