1984 bronco in not firing

Asked by May 19, 2013 at 07:23 PM about the 1984 Ford Bronco II XLT 4WD

Question type: Maintenance & Repair

I have a 1984 bronco ii.  I was trying to figure out why it would die when I
slowed to stop.  I've replaced distributor, rotary coil, distributor cap, rotary
cap, plugs and wires.  It did not fix the dying problem so I was still
working on that.  Now it won't start.  It will turn over and we get fire from
the coil to cap but the plugs are not picking up fire.  Any thoughts?

1 Answer

98,395

You say that the coil is firing but the plugs are not, so you need to check for spark at the distributor coil wire, if you have spark there then remove the distributor cap and check the carbon brush in the center of the cap and make sure it is not broken off or missing, if it is intact then look at the rotor, make sure it is the correct type and not a resistor rotor and not damaged. At this point you should have found the problem.

Your Answer

Ford Bronco II Experts

  • #1
    tennisshoes
    Reputation
    590
  • #2
    Andrew Olsen
    Reputation
    230
  • #3
    Colin Rivet
    Reputation
    220
View All

Related Models For Sale

Used Ford Bronco
176 listings
Used Ford Ranger
172 Great Deals out of 5,549 listings starting at $1,000
Used Ford F-150
2,228 Great Deals out of 182,698 listings starting at $1,500
Used Ford Mustang
755 Great Deals out of 42,814 listings starting at $1,300
Used Chevrolet Blazer
4 Great Deals out of 1,160 listings starting at $950
Used Chevrolet Camaro
422 Great Deals out of 31,920 listings starting at $2,395
Used Ford F-250
472 listings starting at $1,295
Used Toyota Pickup
112 listings

Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use.