low presser fuel pump

Asked by Jun 23, 2017 at 11:00 PM about the 1986 Ford Bronco Eddie Bauer 4WD

Question type: Maintenance & Repair

how do you change the low presser fuel puymp on 1986 ford bronco2.b v6 2.9
not the one in the gas tank.

2 Answers

110,015

The one in the tank is the low pressure pump, the high pressure is the one in the frame rail. So you need to find out what pump is not running, if the low pressure or lift pump has failed sometimes it will run but just won't pull anything, all it will do is idle due to lack of enough fuel to make enough pressure to work the injectors properly.

110,015

Then there is the problems with the fuel regulator, if they go bad they will start leaking fuel into the I take manifold flooding out the engine and putting raw fuel right into the crankcase.

Your Answer

Ford Bronco Experts

  • #1
    tennisshoes
    Reputation
    490
  • #2
    Js08016
    Reputation
    180
  • #3
    Clayton Cameron
    Reputation
    170
View All

Related Models For Sale

Used Ford F-150
2,943 Great Deals out of 230,827 listings starting at $1,300
Used Ford Mustang
332 Great Deals out of 41,501 listings starting at $1,488
Used Chevrolet Blazer
5 Great Deals out of 804 listings starting at $950
Used Jeep Wrangler
376 Great Deals out of 20,576 listings starting at $2,500
Used Ford F-250
425 listings starting at $2,500
Used Ford Ranger
131 Great Deals out of 4,928 listings starting at $499
Used Ford Bronco II
18 listings
Used Toyota 4Runner
355 Great Deals out of 29,588 listings starting at $1,500
Used Chevrolet Camaro
358 Great Deals out of 31,467 listings starting at $3,495

Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use.