86 bronco II no spark

Asked by Jan 20, 2016 at 10:03 PM about the 1986 Ford Bronco XLT 4WD

Question type: Maintenance & Repair

I left a friends at night had all power and
lights got home went out next morning to
start and battery was dead put a new
battery in then wasn't getting spark
replaced. Ingnition module, sylinoid next
getting ignition coil any other ideas of what
it might be

1 Answer


Unplug the coil connector, then put a test light in between the wo connectors then crank the engine and look for a flashing light, if no light disconnect the spout connector and retry, if you get a flashing light the the ECM is bad, if still no flashing light and you have already replaced the ignition module then you need to replace the distributor pickup coil inside the distributor. HTH

Your Answer:

Ford Bronco Experts

  • #1
  • #2
  • #3
    Clayton Cameron
View All

Related Models For Sale

Used Ford F-150
2,280 Great Deals out of 208,576 listings starting at $1,300
Used Ford Mustang
273 Great Deals out of 37,436 listings starting at $1,350
Used Jeep Wrangler
225 Great Deals out of 16,708 listings starting at $3,000
Used Chevrolet Blazer
701 listings starting at $895
Used Ford F-250
398 listings starting at $3,500
Used Ford Ranger
125 Great Deals out of 4,327 listings starting at $1,500
Used Toyota 4Runner
259 Great Deals out of 34,260 listings starting at $1,995
Used Ford Bronco II
18 listings
Used Toyota Land Cruiser
15 Great Deals out of 1,153 listings starting at $5,500
Used Chevrolet Camaro
233 Great Deals out of 27,298 listings starting at $2,077
Used Ford F-100
161 listings

Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use.