transmission seems to get stuck in first gear at a stop, but after code is reset it works fine engine light is on too

transmission seems to get stuck in first gear at a stop, but after code is reset it works fine engine light is on too 1 Answer

I have an 04 with the dreaded 2.7 engine. the engine light is on and giving a code for the crank sensor. it has been replaced...twice. the light is still on and they can't even reset it. 1 Answer

I've tried 3 times to erase the code. The light does not go off and I can't get an inspection.

when the car is started al the guages light up and the tac and speedometer dont and when we put it in gear to drive it stalls 3 Answers

when the car is started all the guages light up and the tac and speedometer dont then when putting in gear to go it stalls

I got a P0340 on my '96 intrepid ES. Cam position sensor. I replaced it, but still no go. Put the diagnostic machine on, and still I get a P0340 code, even with the new sensor. What gives here? 1 Answer

I am only getting one code reading on the OBD reader, and that is the p0340. Not sure what the hell else is wrong, but i am not pushing any other codes. If I blew my timing belt, i am certain I would ...

What is wrong with the shifting in transmission? 1 Answer

I have a 1995 Dodge Intrepid. When the vehicle is cold the transmission will not shift into reverse until the car has warmed up quite a bit. The vehicle will also not shift from first gear to seco...