Why is low side ac pressure high

When the compressor is not engaged it is common for the pressure on the low side to b 100psi and over. This is because the compressor is not compressing the freon. Check the low pressure switch. And now since u bled the freon out u will have to recharge the system once the compressor is working again.

Ok, with the multimeter, what do I measure it on? And with the car ignition on and a/c max, or off. Sorry, have read conflicting things online, and want to do it correctly

First check all the fuses for an a/c clutch fuse, make sure the fuse is good. The owners manual is helpful here cause it lists what each fuse protects. With a good fuse, proceed as follows. The low pressure switch is usually only a two terminal connector. It's the same wire the switch just interrupts the current. With the connector off the switch, take a small piece of wire and jump the terminals. Then start the vehicle turn the a/c on and see if the fans come on and see if the a/c compressor clutch is engaged. If the fans r on but the a/c clutch isn't, the clutch is bad. If the clutch and fans r on then the low pressure switch is bad.

Fuses were good, even traded them out to be sure. Took wire and connected 2 prongs (there were 3, not sure it mattered which ones), started car, a/c max, clutch did not engage, fans on

Are there 3 wires or two?

If u could upload a pic of the connector that would b helpful

Its got 3 prongs

Sorry, I meant the wire side

Ok

Ok then with the a/c on, and engine running, take the multi meter and find the wire with the power, usually 12v. Put the red wire of the multi meter in the power wire, then test the other 2 wires, if u get a reading in either one then the clutch is bad, if no reading then take the wire and put one end in the terminal where the red wire from the multimeter was in. Then insert the other end in the other wires one at a time. If the fans come on check the other wire to see if the clutch comes on. If the clutch does not engage then it is bad. I think one wire runs the fans and the other wire the clutch.

If the clutch engages then the low pressure switch is bad.

Ok, as instructed, found power wire, 5v. When put other probe on other sites, also received 5v on multimeter. So clutch is bad, correct?

Start the car, turn a/c on. U have to have the black wire of the multimeter to a ground, part of the body or a nearby unpainted bolt. Then test all 3 wires with the red probe, there should b more than 5v for the power wire. Keep the red probe in the power wire, test the other 2 wires, if power is found then the clutch is bad, if no power. Put the jumper where the power is and test the other 2 wires, if the clutch engages then the switch is bad, if the clutch does not engage then the clutch is bad. The car has to b running and a/c on.

Car running, a/c on, found power wire. Left red probe on power wire, put black probe, one by one, on other 2 wires, both showing voltage

Ok then it's the pressure switch. Parts store $60 or online for 13.99 on up

I can't possibly thank you enough for your help with this.

Hi, I had same issue , I did same steps , I saw the fan turn on but when I did on the other wire, my car turn off automatically