2011 Jeep liberty brake controller trailer plug location?
Vehicle came with factory installed tow hitch and 7 pin plug in rear. Where is
the trailer brake under the dash or some other location? I can locate it under
the drivers side door threshold but not under the dash.
The Class III trailer package on the Jeep Liberty comes with a 7-way connector at the rear of the vehicle. An installed brake controller on your 2008 Jeep Liberty with a factory 7-Way you will have hardwired wires from the back of the brake controller to the vehicle. This vehicle does not have a brake controller port that you can plug the brake controller into. The four wires on the back of the brake controller are: White: Ground, attached to the vehicles negative battery terminal. Black: 12v power lead, attached to the positive battery terminal with a 20 amp or 30 amp circuit breaker. You can use part # 5506. Blue: Electric brakes, attached to the blue electric brake wire on the 7-Way connector at the rear of the vehicle. Red: Stoplight switch, normally located directly off the vehicle's brake pedal. Attach to the wire on the switch that only has a signal when the brake pedal is pressed. I am including a link to a FAQ page on brake controller wiring. Also, if you have a factory 7-way connector at the rear of your Jeep then you will want to look for a blue (brake controller) wire to be stored up under the drivers side of the dash. It will be taped to the back of another wiring harness. You will run the blue brake output wire from your brake controller to this wire. If you need a brake controller I would recommend the Tekonsha Prodigy P2 Brake Controller, part # 90885. This is the best selling brake controller. I am including a link to the instructions on the Prodigy P2 brake controller
Under drivers side panel
Looking for a Used Liberty in your area?
CarGurus has 7,183 nationwide Liberty listings starting at $1,500.
Search Jeep Liberty Questions
Jeep Liberty Experts