oil pressure switch
changed oil pressure switch on my 2008 dodge ram 5.7 hemi
because the oil pressure went to 0 after engine warmed up..no engine noise..changed it with a dodge part too..and it is still happening what is the cause now,,,any ideas
Your oil pressure is valved either at the oil pump or oil filter housing. Valve may be stuck open. Outside chance oil pump drive shaft is broken from the pump sucking up something it should not have.
Is the oil pump working? but the new switch is reading "0" as well...
put a manual gauge on it make sure your pressure is good maybe you have a bad gauge
joemom you must have mis-worded your answer. I have a lot of respect for your posts. But maybe re-phrase that....? If the oil pump was not working...failed... the the engine would be destroyed in a minute, You know that my friend.
I do I was asking a question how it was going to "0" if the oil pump is working...
My mind is somewhere else, I'm showing my 61 at a car show this weekend, everyone says it looks good , I say it looks like hell, LOL...
Looking for a Used Ram 1500 in your area?
CarGurus has 12,989 nationwide Ram 1500 listings starting at $1,495.
Search Dodge Ram 1500 Questions
Are you a UK consumer? CarGurus now has a discussion forum in the UK.
Dodge Ram 1500 Experts