- Home
- / Questions
- / Jeep
- / Grand Cherokee
- / Check Engine Light On HELP!
Check Engine Light On HELP!
Asked by aj7881 Feb 11, 2014 at 12:31 PM about the 2011 Jeep Grand Cherokee Laredo
Question type: Maintenance & Repair
So the other day my CEL came on and I
went to auto zone to get it read. What it
came back as was a P0302 code stating
that I was having a misfire of cylinder 2,
which could of been caused by a bad
fuel injector, spark plugs, vent leak, etc...I
don't have the money to pay someone to
fix this right now, and I like to do things
my self, but don't have much car
experience under the hood. An I don't
wanna pay a bunch if all it is is spark
plugs I could do my self. Anyone got any
knowledge into this situation? Please
help!
2011 Jeep Grand Cherokee Laredo 72k
2 Answers
thejeepdoctor answered 4 years ago
I would pull a plug and see how worn out it is. Use NGK plugs. Is it kinda jerking or is it a dead miss?
Your Answer
Related Questions
-
Check Engine Light On HELP! 2 answers
So the other day my CEL came on and I went to auto zone to get it read. What it came back as was a P0302 code stating that I was having a misfire of cylinder 2, which could of been caused by a bad...
2011 Jeep Grand Cherokee Laredo
-
Maintenance & Repair
-
check engine light 4 answers
My check engine light is on. I am getting a P 0403 fault code. Does any one know what that means? Where can I get a list of what the fault codes mean? I pulled the negative off the battery and the ...
2009 Jeep Grand Cherokee Laredo 4WD
-
Maintenance & Repair
-
Check engine light
Check engine light went on. Code reader said it was cylinder 2 misfire. Had all three cylinders on left side replaced. Car was good for a week. Light came back on today. Any ideas whats causin...
2011 Jeep Grand Cherokee Laredo 4WD
-
Maintenance & Repair
-
Check engine light came on then went off 2 answers
Check engine light came on had autozone run test and it came back at governor sensor&solenoid. I pulled it up on ramps to work on it but let it sit an hour to allow it to cool down. I then pulled it...
2000 Jeep Grand Cherokee Laredo 4WD
-
Maintenance & Repair
-
Flashing check engine light 1 answer
My 99 jeep grand Cherokee4.0 check engine light started to flash i put new coil pack new plugs new cam shaft sensor and it still dose it how can i tell which of the two Cadillac converters it is i ...
1999 Jeep Grand Cherokee Limited 4WD
-
Maintenance & Repair
Shortcuts
Search Jeep Grand Cherokee Questions
Jeep Grand Cherokee Experts
-
#1inuevafreakReputation2,220
-
#2Tom DemyanReputation2,090
-
#3thejeepdoctorReputation2,010
Related Models For Sale
Used Cars For Sale
Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use.