2010 malibu replaced camshaft sensor now won't start.
I replaced the sensor I was t ok d was messing up
but I took it to auto zone and they said it was my
fuel injectors. Although I had 2 guys look and both
said camshaft sensor. Help me please
What did Auto Zone say the code was?
Check this out... https://youtu.be/_RF4yct8J54
Oh my bad wrong code it's a p0016 and p0172
P0016 CHEVROLET - Crankshaft Position - Camshaft Position Correlation Bank 1 Sensor 'A' ...Possible causes; Mechanical timing fault (stretched timing chain or damage timing chain tensioner), Blocked oil passage, Low oil level, Faulty Intake ('A') Camshaft Position (CMP) Sensor, Faulty Crankshaft Position (CKP) Sensor....If this DTC started after recent internal engine repairs, inspect for proper engine mechanical timing. With the camshaft cover removed and the #1 cylinder at top dead center, make sure that the darkened chain links are lined up with the alignment marks on the exhaust and intake cam sprockets. If a P0016 is resetting without any engine performance concerns but the above information did not isolate a cause for the DTC, replace the Cam Phaser Actuator sprocket........P0172 CHEVROLET - Fuel Trim System Rich Bank 1...Possible causes; Faulty front heated oxygen sensor, Ignition misfiring, Faulty fuel injectors, Exhaust gas leaks, Incorrect fuel pressure, Faulty Mass Air Flow (MAF) sensor.
Wow I'm in trouble. Thank you so much
Ok friend I need help again. I replaced my spark plugs, camshaft sensors and intake solenoid. Still nothing
Ok, Check this out.. www.yourmechanic.com/article/p0016-obd-ii-trouble-code-camshaft-position-a-camshaft-position-correlation-bank-1-by-jay-safford
Looking for a Used Malibu in your area?
CarGurus has 53,721 nationwide Malibu listings starting at $1,250.
Search Chevrolet Malibu Questions
Chevrolet Malibu Experts