we swapped a 2003 subaru outback engine with japanese made forester and we now have an idle air control problem. We replaced the valve twice with used ones still have an issue any thoughts

we swapped a 2003 subaru outback engine with japanese made forester and we now have an idle air control problem. We replaced the valve twice with used ones still have an issue any thoughts 1 answer

we swapped an 03 outback engine with a forester engine. The problem we are having is the check engine light for an idle air control valve. We replaced it twice with used ones and are still having a problem 7 answers

I removed a gen 1 2.5 dohc from my 99 legacy outback. I installed a gen 2 2.2 from my 99 impreza sport. Problem is the intakes are different. I can't find a gen 2 with the same idle air control as the 2.5 gen one and egr. can I swap to gen one heads and run a gen 1 2.2 intake? 5 answers

Engine swap that has not been quick. Is there a gen 2 2.2l intake that would have an egr port and the same idle air control as the gen 1 2.5 dohc? I have located one with the egr port covered by a p...

Have any of you had problems with your front drivers side brake caliper sticking? 2001 Subaru Outback 1 answer

I was thinking i had a wheel out of balance because i was getting a shake in my steering wheel. So i went to Schwabs and the balance all the wheels. Then they put it on the alignment rack and guess ...

Subaru Outback 2005: Limp Mode 12 answers

I have been battling a big boost upon acceleration at stoplights for approximately 6 months. Now twice I have gone into limp mode and the tech reads: PO700 (Transmission) and PO731 (Gear 1). I just tu...