i have a 93 2wd 1/2 ton to 3/4 ton front suspension

65

Asked by Feb 03, 2012 at 11:00 PM about the 1993 Chevrolet C/K 1500 Silverado Extended Cab SB

Question type: Maintenance & Repair

i was wanting to put the 2500 front suspension on so i can run 6 lugs and have a wider selection for rims. i know in the back all i have to do is swap the axle shafts for the 30 spline 6 lug ones off a 10 bolt rear end. i didnt know if i could just get the 6 lug 2wd rotors for the front and put them on the 1/2 ton spindles or not.. or if it is even possible

2 Answers

34,945

Cross reference the 1500 control arms to a 2500. If the numbers are the same then there should be no problem putting a knuckle made for a 6 lug on the truck. If it comes down to it get upper and lower control arms and a knuckle.

65

thanks. i already got it figured out lol. they have the same spindles.. upper control arms are a bit different but they still fit. but to switch to the 6 lug rotors you dont need to change anything else.

Your Answer

Chevrolet C/K 1500 Experts

  • #1
    Andrew Olsen
    Reputation
    3,590
  • #2
    John Saffrahn
    Reputation
    2,570
  • #3
    Rowefast
    Reputation
    2,170
View All

Related Models For Sale

Used GMC Sierra 1500
888 Great Deals out of 65,336 listings starting at $1,995
Used Ford F-150
2,317 Great Deals out of 182,094 listings starting at $1,000
Used Chevrolet C/K 2500
198 listings starting at $6,495
Used Dodge Ram 1500
392 Great Deals out of 10,914 listings starting at $1,500
Used Chevrolet C/K 3500
229 listings starting at $4,999
Used Chevrolet Camaro
412 Great Deals out of 30,659 listings starting at $3,550
Used Chevrolet S-10
8 Great Deals out of 1,217 listings starting at $2,500

Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use.