need to replace oil inlet stripped hex on super charger

Asked by Mar 21, 2017 at 11:35 PM about the 1996 Buick Park Avenue Ultra FWD

Question type: Maintenance & Repair

super charger cone oil  "refill hole"  has a stripped hex and can not be backed out. Any suggestions ???

2 Answers

2,490

If it were mine (I happen to have a wire feed welder) I would tack weld the hex wrench in the wrench hole....that would allow you to turn and pull at the same time. I think that plug has an "o" ring so you could carefully put in a Helicoil or maybe one of those rubber pan plugs.

Best Answer Mark helpful

Thank you. I did it with JB cold weld, worked great and easy for future use also. you are the best ! Knight

Your Answer:

Buick Park Avenue Experts

  • #1
    Jking1838
    Reputation
    1,230
  • #2
    jateen29
    Reputation
    1,210
  • #3
    Tom Demyan
    Reputation
    860
View All

Related Models For Sale

Used Buick LeSabre
1,343 listings starting at $1,499
Used Buick Regal
92 Great Deals out of 3,649 listings starting at $1,995
Used Chevrolet Impala
517 Great Deals out of 26,173 listings starting at $995
Used Buick Century
555 listings starting at $1,995
Used Cadillac DeVille
1,274 listings starting at $999
Used Mercury Grand Marquis
18 Great Deals out of 1,296 listings starting at $1,196
Used Lincoln Town Car
31 Great Deals out of 1,455 listings starting at $899
Used Ford Crown Victoria
4 Great Deals out of 747 listings starting at $2,995
Used Buick Roadmaster
47 listings
Used Toyota Camry
882 Great Deals out of 72,153 listings starting at $1,000
Used Honda Accord
719 Great Deals out of 103,450 listings starting at $849

Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use.