Have a 95 Buick Park Ave. w/3.8 V-6 I installed new ICM, ICM 14 wire connector I replaced all the wires from the connector one by one. Also installed new coil-packs all three. The car stalled on me and wouldn't start. The engine cranks but doesn't start. Checked for spark engine has spark. All the power windows don't work and neither do the power door locks. Checked cam sensor seems to be ok a little corrosion around the inlet of the sensor. Also checked to make sure the interrupter was on the timing gear and it is what the heck is the problem?

75

Asked by Nov 15, 2015 at 08:08 PM about the 1995 Buick Park Avenue FWD

Question type: Maintenance & Repair

1 Answer

77,935

Since you know that it has spark spray some starting fluid down the throttle body. It should run on the starting fluid for a few seconds. If not, run a compression test. If all cylinders test low or zero it's jumped timing. HTH. - Jim

Your Answer

Buick Park Avenue Experts

  • #1
    Jking1838
    Reputation
    1,190
  • #2
    jateen29
    Reputation
    970
  • #3
    Tom Demyan
    Reputation
    840
View All

Related Models For Sale

Used Buick LeSabre
1,238 listings starting at $686
Used Buick Regal
82 Great Deals out of 4,088 listings starting at $3,995
Used Lincoln Town Car
24 Great Deals out of 1,358 listings starting at $1,995
Used Cadillac DeVille
1,272 listings starting at $1,988
Used Chevrolet Impala
397 Great Deals out of 25,595 listings starting at $799
Used Buick Century
570 listings starting at $1,200
Used Mercury Grand Marquis
19 Great Deals out of 1,192 listings starting at $1,200
Used Ford Crown Victoria
710 listings starting at $1,700
Used Chevrolet Caprice
126 listings starting at $1,350

Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use.