92 S 10 WONT FIRE
My 92 s10 will not fire i have replaced fuel pump /injectors im getting fuel and spark but no fire it wants to start at first but wont ?? any suggestions
did you check the distributer?
If you have sparkand you have fuel, then realisticly it should run, unless you have a bad ignition module in your distributor, then you have probably jumped time, making the spark and fuel not at the same time......
its something electricall these trucks are allways fkn up with electrical sht
try changing the ignition coil....?
is your crank sensor giving any signal?
Do a compression test before wasting time and money good compression is 180 -120 is optimal anything UNDER 90 will not fire the hole if all cylinders are 80 or less you need a timing chain set. If this engine was overheated head gasket(s) will need repaired first.
need to cheak oil pressure gaug if oil pressure is to low it could cause it to shut down oil senser well keep it fromstarting \
Looking for a Used S-10 in your area?
CarGurus has 1,630 nationwide S-10 listings starting at $1,399.
Search Chevrolet S-10 Questions
Are you a UK consumer? CarGurus now has a discussion forum in the UK.
Chevrolet S-10 Experts