Where is my vehicle information button to reprogram remotes?

Asked by Feb 01, 2014 at 03:19 PM about the 1993 Buick Roadmaster 4 Dr Limited Sedan

Question type: General

I am trying to reprogram a new remote due to the old one being broken. I need to locate the vehicle information button in order to sync up the remote. Please help

2 Answers

505

You can give the vendor that will replace the unit your cars VIN# (located on the bottom left of your dash see thru windsheild) and then they can get you a replacement.

140

Go to the junkyard and find a remote from a Roadmaster then do this: 1991 - 1996 BUICK ROADMASTER REMOTE REPROGRAMMING PROCEDURE There is a "programming connector" plug with two wires, both black and white striped, coming into the backside of the plug and nothing plugged into the plug. To reprogram the remote keyless system, you will put a paper clip or some short wire into the plug to connect across the two terminals to connect the wires together. If you redo one transmitter, you will have to redo all transmitters.Connecting across the two terminals in the "programming connector" will make the system forget about all of your transmitters. 1. Sedan: look for the connector inside the left side of the trunk compartment behind the insulation. 2. Wagon: remove the right back body pillar finish panel to access the connector. 3. Using a paper clip or some short wire, connect across the two terminals in the connector. The system will click as it locks and then unlocks the locks. 4. Press any key on your transmitter. The system will go through the lock unlock cycle again a couple of times to confirm the reprogramming. 5. If you want to disable the unlock on shifting into Park feature, perform the following sequence three times with no more than one second between presses. Press the door lock button, press the door unlock button, press the trunk button. Repeat the sequence two more times with no more than one second between button presses. The receiver will cycle through the lock, unlock, trunk sequence three times as verification. 6. To program a second transmitter to the car, repeat steps 4, and if desired step 5. 7. Disconnect the paper clip or short wire across the two terminals on the "programming connector". 8. Now for the step which isn't in the manual. Use one of the transmitters to lock and then unlock the doors before cranking the engine to test it. 9. Now, you are finished.

Your Answer

Buick Roadmaster Experts

  • #1
    DanR63
    Reputation
    460
  • #2
    Rowefast
    Reputation
    280
  • #3
    Tom Demyan
    Reputation
    240
View All

Related Models For Sale

Used Chevrolet Caprice
175 listings starting at $9,970
Used Chevrolet Impala
611 Great Deals out of 34,797 listings starting at $1,250
Used Buick Century
801 listings starting at $1,999
Used Chevrolet Corvette
248 Great Deals out of 22,275 listings starting at $2,500
Used Cadillac DeVille
1,685 listings starting at $1,988
Used Chevrolet Camaro
424 Great Deals out of 31,920 listings starting at $2,395
Used Buick Park Avenue
428 listings starting at $1,800
Used Lincoln Town Car
43 Great Deals out of 1,785 listings starting at $1,495
Used Chevrolet Suburban
288 Great Deals out of 20,436 listings starting at $1,000
Used Lincoln Continental
12 Great Deals out of 4,559 listings starting at $36,951
Used Ford Mustang
752 Great Deals out of 42,817 listings starting at $1,300

Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use.