How can I repair oil pressure sensor when oil pressure lights on dash and a repeated beeping noise?

Asked by Jun 07, 2015 at 10:58 PM about the 1995 Volkswagen Cabrio 2 Dr STD Convertible

Question type: Maintenance & Repair

I had an oil leak, so I replaced 2 sensors.  It beeps after 2000 rmp's & oil pressure light shows on dash.

1 Answer

4,855

It is possible you put the sensors in the wrong position. One is a low pressure sensor and one is higher pressure. They look very similar. Check part-numbers on them and compare to your manual to be sure they are correctly places. Also, be sure to run the proper viscosity of oil as that can also cause pressure warnings. This fault is perennially discussed on most VW forums. Check out the forum community on VWVortex dot com for more tips and assistance.

Your Answer

Volkswagen Cabrio Experts

  • #1
    Tom Demyan
    Reputation
    4,790
  • #2
    Mike Bonnell
    Reputation
    1,240
  • #3
    Fkpeach
    Reputation
    850
View All

Related Models For Sale

Used Volkswagen Golf
109 Great Deals out of 3,740 listings starting at $1,500
Used Volkswagen GTI
158 Great Deals out of 6,208 listings starting at $1,490
Used Volkswagen Jetta
661 Great Deals out of 35,941 listings starting at $900
Used Jeep Wrangler
504 Great Deals out of 19,435 listings starting at $2,500
Used Volkswagen Passat
532 Great Deals out of 26,944 listings starting at $1,500
Used Toyota Camry
1,079 Great Deals out of 86,843 listings starting at $800
Used Mazda MX-5 Miata
74 Great Deals out of 4,204 listings starting at $2,995
Used Honda Accord
1,132 Great Deals out of 73,674 listings starting at $1,100

Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use.