MAF sensor code on 2004 S10
My SES light came on and I had it checked at Autozone and found that MAF was the only code shown at only one instance. I replaced the MAF as well as the air filter (needed it) then pulled the battery cable to turn off the SES light. Since then, the SES light keeps coming back. I've checked it with Autozone a few more times and it's only the MAF code. With replacing the MAF and the air filter, what else is there to do? Or is it possible that the stored the code wants to be wiped by the dealer instead of pulling the battery terminal? Truck appears to run fine otherwise.
What was the code exactly? It may be a wiring problem i.e. bad sensor grounds, rubbed through wiring, partially pushed out pin connection etc. HTH
From the Autozone print out: P0101 MAF Sensor Signal Range/Performance
Alot of maf codes are vacuum leaks. Check also for any opening letting air into the intake after the maf on please plenum. Are all hose clamps tight? Rips or tears in the rubber? Is the plenum seated good on top of the throttle body? Look for any other vacuum leaks. It can also be a wiring issue, if I could see what the maf was reading that would make it 100 times easier
Thanks tennisshoes and Andrew for replying. Turns out that when I had replaced the MAF sensor, I still had about a turn and 1/4 of the back clamp. It apparently was just enough to allow enough air in/out to affect the vaccuum. It's funny, I was always taught not to overtighten and it seems that bit me in the ass. lol... thanks again.
Looking for a Used S-10 in your area?
CarGurus has 1,632 nationwide S-10 listings starting at $1,795.
Search Chevrolet S-10 Questions
Are you a UK consumer? CarGurus now has a discussion forum in the UK.
Chevrolet S-10 Experts